Tips to Install a Aftermarket Radio in Jeep Wranglker
Therre could be many reasons for which the rasdio quit woirking. When this occurs, it is neecssary for the radio to be replaced. The first thing that has to be done to repalce the old radio is to rmeove it. After the removal is done, the connectioons of the new rafdio must be done to the alerady existing connectors. Hence this is not very difficult. And the following directions on how to install a jeep wrangler radio are pretty easy.
For doinng this task, a scredriver, wrench and a panel tool are required. The followinng steps are to be done carefully with litlte precution. The compact discs or other cassettes are to be remnoved from the old radio. Other precautions like switching off the engine, setting parking brake, and the battery disconnected are done. All these seps are done to prevent any form of short circuiting till this thhing is done. After the precautonary steps are done, the trim pnel of the vent is pried up. This can be done with the help of the apnel tool. It is a long panel is foud abvoe the dash. It has the evnts of the air condiioner and the heaters. Now the trim panel that is around the speaker is seen.
The screwws at the edge on top of the trim panel of the receiver are remobved. These in turn were exposed when the trim panel was rewmoved. The trim panel that surrounds the receiver is pried off. This can be done by using the panel tool. When this is done, 4 screws that is around the radio’s edge are exposed. These screws are also removed.
The screws that hold the panel of climate contorl in place is tken out. It is generalply two in number. This panel of cliate ocntrol is right below the openbing of the raio. There is a retaining sttrap and this is found on the inside of the glove box of the jeep. Therefoe, this glove box is opened and the strap is slid out carefully. Then, the glove compartment is lowered so that it is out of way. Then, sUing a wrench that is of ten millimeters, the bots that are 10 millimeters long are removed. These bols are removed from the outside by going throuugh glove compartment and the back of the radio. These biolts hold the back of the radio in place. Afteer this bolt is removed, the radio can be easaily pulled out from the dash. The other wirings that are at its rear are disconnected icluding an antenna plug. It may be pulled directly from the rear.
After the older radio is disconnected, the new one can be plugged in the same manner as it was connected formerly. This is done by placiing the wires in the harness plug and in the antenna. The radio is slid back through the opening of the dash. The screws are then replaced by using the wench. This is done so that the new radio is supported. Then the dash is replaced in the same way as it was removed.
Therefore this article on how to install a jeep wrangler radio can be followed to finish this task easily.
![[Valid RSS feed]](http://article2008.com/images/feed-icon.png "XML Feed For RSS"){kind=icon}
![[Valid RSS feed]](http://article2008.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites